How to Install Fontana Luxurious Recessed Large LED Waterfall Rainfall Shower System With 6 Body Jets Hand Shower | FS7394
Installation Instructions for Bathroom Shower Set
Visit Product Page
Before installation, kindly review these installation guidelines:
Observe all local building and safety codes.
Unpack and inspect the products for any shipping damages. If you find damages, DO NOT install.
Please note all products must be installed by a professional and certified plumber otherwise warranty might be voided.
shower
Shower Head Installation Instructions
Size:
Step 1: Cut out a hole in the suspended (false) ceiling, install the fixture and mark the locations on the ceiling for the mounting plugs.
shower
Step 2:Make 4 Ø11 holes at the marked locations, push the mounting plugs into them and drive them home with the hammer
Step 3: Screw in 4 bolts into the plugs and lock them with the nuts.
Step 4: Cut the bolts to size, if necessary, as shown in the drawing.
Step 5: Insert the fixture into the suspended ceiling hole.
Step 6: Adjust the installation height by turning the nuts.
Step 7: Hoist the fastening cables.
Step 8: Connect the supply lines.
Step 9: Insert the rain shower assembly into the fixture.
Step 10: Tighten the 4 mounting bolts and insert the LED shrouds.
Shower System Installation Instructions
Assembly Diagram:
Wiring Connections:
Water Supply Connections:
Function Box Installation
Step 1: Prepare the installation location for the function block.
shower
Step 2: Fasten the function block with screws. Step 3: Connect the hot and cold water supply and the electrical wiring according to the diagrams.
Cleaning the filters:
1. Close the hot and cold water supply to the function block.
2. Remove the nuts of the supply hoses.
3. Remove the filters.
4. Use a brush to remove all dirt and impurities.
5. Reassemble the filter, tighten the hose nuts, and open the hot and cold water supply.
Use the approved installation drawing and intended user range to determine elevations and spacing. Keep all jet fittings level and at the specified finished-wall depth.
Open Body-Jet Guide
Why must flow demand be reviewed?
A showerhead, handheld and multiple jets can create substantial combined demand. Confirm suitable pressure, supply sizing, water-heater capacity and drainage.
Review System Requirements
When should jet branches be tested?
Flush and pressure-test the complete distribution assembly before waterproofing and tile. Inspect every fitting while it remains accessible.
Open System Guide
Where are the remaining component guides?
The main installation hub provides related instructions for mixers, overhead showers, handheld outlets and concealed rough-ins.
Open Installation Hub
.png)
